Revised: 04/22/08

HMIS Health-1 Flammibility-3 Reactivity-0

SECTION I-Product Information

Manufacturer: A.V.W. Inc.

24 Hour Emergency Phone Number: 800-424-9300

Product Name: Get Off Ink & Adhesive Remover

SECTION II

Hazardous Ingredients

2-Butoxyethanol CAS# 111-76.-2 TWA 100 % 20-40

Isopropanol CAS# 6763-0 TWA 400 20-30

Mineral Spirit CAS# 8052-41-3 TWA 200 20-30

Propane CAS# 74-98-6 TWA1000 18-23

Butane CAS# 106-97-8 TWA 800 12-17

SECTION III

Physical Data

Boiling Point: 188 F

Specific Gravity (H₂O=1)=0.86

Solubility in water: .0%

Appearance: Colorless liquid with penetrating cellosolve odor

SECTION IV

Fire and Explosion Hazard Data

Flash Point: 98F Extremely Flammable Level 3 Aerosol

Extinguishing media: Water, CO₂, and foam, dry chemical

Special fire Fighting Procedures: Do not expose containers to temps above 120° F.

Unusual fire and Explosion: Forms flammable vapor-air mixtures. Lower temperatures increase the difficulty of getting it to ignite.

SECTION V

Health Hazard Data

Time weighted average (TWA): 100 ppm based in the raw material.

Carcinogen: NO

Acute chronic health effects: Excessive exposure may cause irritation to upper respiratory tract. Excessive exposure may cause carboxyhemoglobinemia, they’re by impairing the blood’s ability to transport oxygen.

Primary Routes of Entry: X Inhalation X Skin X Ingestion

Effects of Overexposure: Eyes-May causes pain, moderate eye irritation and slight corneal injury. Vapors may irritate eyes.

Skin: May cause irritation. Repeated contact may cause drying or flaking of skin.

Inhalation: In confined or poorly ventilated areas, vapors can readily accumulated and cause unconsciousness and death.

Ingestion: May be harmful.

Emergency First Aid Procedures: Eyes- Flush with water 15 minutes. Get medical attention if irritant persist.

Skin: Wash with soap and water.

Ingestion: Do not induce vomiting. Get medical attention immediately.

Inhalation: Move to fresh air. Get medical attention

SECTION VI

Reactivity Data

Stability: stable X

Conditions to Avoid: Hydrolysis producing small amounts of hydrochloric acid possible with gross water contamination.

Avoid open flames, welding arcs, or other high temperature sources, which induce thermal decomposition.

Incompatibility: Strong Oxidizers; caustics, chemically active metals such as aluminum, magnesium & sodium.

SECTION VII

Spill or Leak Procedures

Steps to take in case material is released or spilled: Use absorbent material and trash receptacle. Waste disposal method Federal and Local regulations.

SECTION VIII

Special Protection Information

Respiratory Protection: Adequate ventilation.

Gloves (type): Chemical resistant

Eye protection: Glasses if required

Other Protective Equipment: None

SECTION IX

Special Precautions

Precautions to be taken in handling and storing read and follow all label directions. Do not store containers at temperatures above 120°F.